|
LABEL SETUP (Shift-Style)
To select the LABEL SETUP function
hold down the SHIFT key and push the STYLE key. You'll
see a prompt (shown below) appear. The menu options
are: length, cutmark, left margin and vertical margin.
Length:
In the default setting, the LENGTH
of a printed label automatically adjusts to fit the
length of the text. If you want to specify the length
of a label, the LENGTH function allows you to set the
length between 0.3" and 20". To turn AUTO
off, type in the specific length you want and push ENTER.
To exit the length menu without making any changes,
push the DEL key.
Cutmark:
 The
CUTMARK function creates cutmarks along a print job,
as shown in the example to the left.
Use the left/right cursor keys to
move the cursor to the left of CUTMARK and push the
ENTER key. When turned on an askerisk will apear. To
turn CUTMARK off, press the ENTER key again. To exit
the menu without making any changes push the DEL key.
Left Margin:
The LEFT MARGIN function allows you
to increase the size of your left margin by moving text
from the left to the right of your label. The amount
is measured in pixels. Use the left/right cursor keys
to move the cursor to the left of LEFTMARGIN and push
ENTER. A prompt will appear. Use the left/right cursor
keys to select an increment, up to 30 pixels. Push the
ENTER key to select the increment. See the example below:
This function is used with die cut
labels and self-laminating wire wraps only:
 The
text seen here has printed right to the edge of
the label. |
 |
 The
text is now adjusted. |
|
Vertical Margin:
The VERTICAL MARGIN function allows
you to move text from the top to the bottom by pixel
on your label. Use the left/right cursor keys to move
thecursor to the left of VERTMARGIN and press ENTER.
A prompt will appear below. Use the left/right cursor
keys to select an increment up to 30 pixels. Push the
ENTER key to select the increment you've chosen. See
the example below:
|
