The 9600Ki is equipped with a USB port, allowing
you to use a USB cable to connect the printer to your
computer. Once connected to your computer and can
print labels using the Editor Software.
| NOTE |
|
 Do
not connect the 9600Ki to the computer before
installing the Editor software, otherwise it
may not be installed correctly. Follow the software
installation procedure in the user's manual
to install the Editor software and printer driver--and
connect the 9600Ki to your computer when you
are instructed to do so.
|
To
connect a computer to the 9600Ki through the USB port.
First, be sure the 9600KI is turned off.
Insert
the flat (A) connector on the USB cable into a USB
port on the computer.
Insert
the square (B) connector on the USB cable into the
USB port on the right side of the 9600Ki. See the
image below.
Turn on the 9600Ki.
After
the 9600Ki is connected to a computer using a USB
cable, the 9600Ki enters Interface mode when data
is sent to it from the computer.
To exit Interface mode for a USB connection and return
to the text, press any key.
The 9600Ki can not enter Interface mode for a USB
connection while it is printing, feeding tape or in
Interface mode for an RS-232C connection, or while
a macro is being assigned to a PF key.
