KSun 9600Ki Free Online Tutorial

KSun 9600Ki Tutorial - Error Messages

Table of Contents [ Error Messages 1 - Error Messages 2 - Error Messages 3 ]

9600Ki Error Messages
16 Line Limit	50 Line Limit Reached!	Batteries Weak!	Buffer Empty!
Buffer Full!	Can't Feed AV Labels!	Cassette Changed!	Change Adapter!
Charge Batteries!	Close Cassette Cover!	Cutter Error!	EPROM Error!
Feed Error!	Input Whole Code!	Interface Error!	Invalid Characters!
Length Limit!	Line Limit! XX Lines Maximum	Memory Full!	Min 4 Digits!
No Files!	No Tape!	Replace Batteries!	Set XX Tape!
Set AVI1789 Tape!	Set AVI1957 Tape!	Set AV2067 Tape!	Set Stamp-X!
Tape End!	Text Too High!	Text Too Long!	Value Out Of Range! Check Value And Re-Enter

ERROR MESSAGE	CAUSE	SOLUTION
Charge Batteries!	This message appears when the rechargeable Ni-MH battery has reached a low voltage.	Recharge the battery or use the AC adapter.
Close Cassette Cover!	This message appears if the tape compartment cover is open.	Close the compartment cover.
Cutter Error!	The message appears if the cutter did not operate correctly.	Turn off the 9600Ki, then turn it back on again. If this does not correct the problem, contact our service department.
Eeprom Error!	This message appears if a checksum error occurred when the 9600Ki was turned on or if the keyboard was damaged failed to initialize.	Contact our service department.
Feed Error!	This message appears if the LabelLab label sensor can not detect the labels.	Replace the LabelLab label cassette with one that is not empty. If this error message appears even after a new LL label cassette is installed, the sensor may be damaged. Contact our service department.
Input Whole Code!	This message appears if the correct number of digits is not entered in the bar-code data.	Input the correct number of digits or change the number of digits set in the bar-code parameters.
Interface Error!	This message appears if the wrong port is selected for a USB connection.	Windows: Under "Print to the following port" in the printer Properties dialog box, select "PTUSB:" for the USB connection. Windows 98 & ME: If two or more of the same LabelLab models are connected through their USB ports, instead of "PTUSB:", select "PTUSB (PT-3600/9600-XXXXXXXXX): (where XXXXXXXXX is the serial number of the machine). Windows 2000 & XP: The 9600KI can be added as a second printer. Macintosh: In the Chooser, select the 9600KI as the printer.
Interface Error!	This message appears if the wrong port is selected for a serial (RS-232C) connection.	Specify the correct settings for the Baud Rate, Bit Length, Parity and Busy interface parameters. Check that the interface cable is correctly connected.
Invalid Characters!	This message appears if a time stamp or user-defined character image is selected when you try to use the Numbering function.	Select text or a bar-code before trying to use the Numbering function.