KSun 9600Ki Free Online Tutorial

KSun 9600Ki Tutorial - Setting Fonts

Table of Contents - Formatting - Setting Fonts - Size Function

Font Function (FONT)

With the FONT function you can change the font of the text using any of the ten fonts included in the 9600Ki. The table below shows those ten fonts:

Samples of Fonts

Fonts may be changed globally, for a block, or for individual lines.

To change the font:

1 ) Place the cursor in the block or line of text to be formatted (this is not required for global formatting).

2 ) Hold down the CODE key and press either the GLOBAL, BLOCK or LINE keys.

NOTE

This step may be skipped if the settings for several format functions are being applied at the same time.

3 ) Press the left/right cursor keys until FONT is displayed. The setting for the text at the cursor's current position is shown in the smaller print at the bottom center of the display and a sample can be seen on the right side.

Font display

4 ) Select the desired font using the up/down cursor keys. When you are finished selecting characteristics and settings, push the RETURN key to apply the font setting.

To return to the text without making any changes, push the CANCEL key.

NOTE

If "*****" appears as a setting, the Font function has already been applied to part of the current text. For example:

A line in the current block has a FONT set, and the Block or Global format function is being set.

A block has a FONT set, and the Global Format function is being set.

Changing the setting will cancel the setting that was previously applied.

To return the function to its default setting (HELSINKI), press the space bar.

To apply several format settings, continue to use the left/right and up/down cursor keys to make selections until you have selected all of the desired settings.

Only after all settings have been selected should the RETURN key be pushed to apply those settings.