KSun 9600Ki Free Online Tutorial

KSun 9600Ki Tutorial - Machine Adjustments - HALF CUTTER Setting

Table of Contents - Head Adjustment - Half Cutter - USB ID Selection

This function allows you to adjust how deep a half cut is cut with laminated tape, for example, if the tape is cut too much or not enough. Normally, it is only necessary to change the setting by one. If the half cut is still either too deep or not deep enough, change the setting by one again.

If the tape is still not cut correctly, even after this setting has been continuously adjusted, the cutter may be dull. Contact your service representative.

To Change The HALF CUTTER Setting

1 ) Hold down the CODE key and press the letter "A" key.

NOTE

This step may be skipped if settings for several Setup Functions are being applied at the same time.

2 ) Press a left / right cursor key until HALF CUTTER is displayed as shown below.

3 ) Press an up / down cursor key until the desired setting is displayed. To cut less deep, select a lower value. To cut deeper, select a higher value. Adjust the setting in small steps.

To return the HALF CUTTER setting to its default setting (0), push the space bar.

4 ) Press the RETURN key to apply the setting.

NOTE

To apply several Setup settings at the same time, continue pressing the left / right cursor key to select a function. Then press the up / down cursor key to select the desired setting. Press the RETURN key only after all the functions you wish to change have been set.