KSun 9600Ki Free Online Tutorial

KSun 9600Ki Tutorial - Tape Length Function

Table of Contents - Tape Margin - Tape Length - Block Margin Function

Tape Length Function (T. LENGTH)

Although the length of the printed label automatically adjusts to fit the length of the text, there may be times when you want to make a label with a specific length. The TAPE LENGTH function allows you to set the label length between 0.25" and 38.84" (0.6 cm and 99.5 cm).

The current Tape Length setting is shown in the lower-left corner of the display. In the example below the Tape Length is set to "AUTO".

NOTE

The Label Length setting can only be applied to labels printed on tape. The label length of die-cut labels can not be adjusted.

To change the Label Length setting:

1 ) Hold down the CODE key and press the GLOBAL key.

NOTE

This step may be skipped if the settings for several format functions are being applied at the same time.

2 ) Press the left/right cursor keys until T.LENGTH is displayed. The current setting is shown in the left center of the display. A diagram illustrating the tape length measurement is shown on the right side of the display.

3 ) Use the up/down cursor keys to select the desired tape length setting. Or use the number keys to type in the desired tape length. Press RETURN to save this setting.

To return to the text without making any changes, push the CANCEL key.

NOTE

To change the setting in 0.1" (1.0 cm) steps, hold down either the up or down cursor key until the desired setting is reached. To return the function to its default setting (AUTO), press the space bar. The tape length is displayed in the currently selected unit of measurement (inches or centimeters). The unit of measurement can be changed with the Setup Functions. To apply several format settings, continue to use the left/right and up/down cursor keys to make selections until you have selected all of the desired settings. Only after all settings have been selected should the RETURN key be pushed to apply those settings.