KSun 9600Ki Free Online Tutorial

KSun 9600Ki Tutorial - Machine Adjustments - TAPE LENGTH ADJUST Setting

Table of Contents - Contrast Setting - Tape Length Adjust - Head Adjustment

When printing a label with a specified length (Tape Length Function), the length of the printed label may be slightly different. This function allows you to adjust the length of the printed label.

NOTE

If the tape length cannot be adjusted satisfactorily using this function, small adjustments can be made to the tape length using the Tape Length Function.

To Change The TAPE LENGTH ADJUST Setting

1 ) Hold down the CODE key and press the letter "A" key.

NOTE

This step may be skipped if settings for several Setup Functions are being applied at the same time.

2 ) Press a left / right cursor key until TAPE LENGTH ADJUST is displayed as shown below.

Changing the tape LENGTH ADJUSTment setting.

3 ) Press an up / down cursor key until the desired setting is displayed. To decrease the label length, select a lower value. To increase the label length, select a higher value. To return the TAPE LENGTH ADJUST setting to its default setting (0), push the space bar.

4 ) Press the RETURN key to apply the setting.

NOTE

To apply several Setup settings at the same time, continue pressing the left / right cursor key to select a function. Then press the up / down cursor key to select the desired setting. Press the RETURN key only after all the functions you wish to change have been set.