ERROR MESSAGE |
If you have done this: |
The problem (or solution) may be this: |
CALL SERVICE |
A failure requiring technical assistance has occurred. |
Graphic Products' customers can Call for assistance. |
CANNOT ENTER |
You have just requested reversed colors on a label item |
Colors have already been reversed within this label segment. |
You have just requested underlining for a complete line. |
The line contains a bar code
|
You have just appended a bar code. |
Two lines have already been created above the bar
code. The bar code cannot be used with more than one line of text.
Or there is already a bar code in the zone. |
You have just requested reversing colors. |
The selected area overlaps a frame.
|
CAPS LOCK ON |
You have just selected a character size. |
The character size selected is the highest possible for the width of the adhesive tape used. |
|
You have attempted to use lower case characters. |
The character size selected is the highest possible for the
width of adhesive strip used and lower case characters can not be accepted. |
FRAMING IMPOSSIBLE |
You have just activated the 
function. |
The selection already has a frame,
inside another frame or an overlap with reverse function.
|
INCORRECT SEQUENCE |
You have just validated the second value in the sequence. |
The second value is lower than the first. |
INCORRECT STEP |
You have just entered the incrementation step in a sequence. |
The sequence incrementation step exceeds the last sequence value. |
SPACE TOO LARGE |
You have just selected a predefined length and specified a spacing value using the SPACE function. |
Reduce the spacing percentage. Or, increase the label's length. |
SYSTEM ON LINE |
You have activated the INTERFACE function. |
 |
TAPE TOO SMALL |
The cartridge of tape used is too narrow for the character size. |
Install a cartridge with a wider adhesive tape. |
You are in a vertical zone, and the characters are too large. |
Reduce character sizes.
|
This message persists after installing the right cartridge. |
Check that the cartridge identification holes used by the LS250 are uncovered. |
The message persists. |
Graphic Products' customers may
call
for assistance.
|
